I don't know which "scale" but small A-wing LOL

[3d-builder]

I have most of this on the RI so I will post a link to it,
and continue the present build here.
http://resinilluminati.com/showthread.php?t=8152

---

The latest is here

Ah....
After cutting the f-16 like intakes out on the bandsaw I needed a way
of cutting them in half. I could have used the band saw but didn't want
to loose the thickness of the blade on the pattern.

So I used this "Real" thin saw I had from Micro-mark,
to keep the saw cutting at 90deg I used two 123 blocks
to guide it.



Next up some vector rings, that go at the rear of the engines
just some PVC cut and filled with some 2 part modeling clay.


For scale the ring on the left is a SS size vector ring!!



ext I just took the remaining clay I had and started to fill in the cross
sections.Every thing in this pic is pretty lumpy but will get sanded!


This pic shows some sanded parts canopy, canopy bulkhead,
1 engine set, vector rings, rear intakes.


Thats about where i am at for the moment!