10-21-2018, 09:53 PM
As promised, here is the comparison photo with the original model (at the same stage of construction).
I'm pretty happy with the match.
I continue to make minor tweaks as I go, but I think this will only end when the model is finally finished - which I hope is not too far away! 😁
The clamp assembly covering the top armature opening doesn't appear to match well, but this is because it was later shortened to fit into the release arm that Martin Bower built for it.
Next up, is detailing the top side...
I'm pretty happy with the match.
I continue to make minor tweaks as I go, but I think this will only end when the model is finally finished - which I hope is not too far away! 😁
The clamp assembly covering the top armature opening doesn't appear to match well, but this is because it was later shortened to fit into the release arm that Martin Bower built for it.
Next up, is detailing the top side...