10-17-2010, 02:10 PM
I've added a few test fitting pics of the hanger bay pieces fitted into the Engineering hull. Because each of the DeBoers models has variances on the insides of the hull I have to be very carefull with the test fitting. I found out that the middle wall section that I've built are going to have to be trimmed so they can fit into the hull space. The upper part of my scratch build part hits the inner wall of the hull and causes it tonot allow the pieces to fit properly. Sometimes you just cant rely on mathamatics to enlarge a piece for the models. These scratch build models need to be built with great care as the DeBoers model and all of the pieces must be very customized to fit in there properly. But... with a little TLC and some tweaking it will all work out. I should have a complete hanger model to show you next week or so and then start casting 3 of them for the other Enterprise models. See you next update.
~NemVia~
http://www.NemVia.com
"... once it's activated, there's no way to stop it!" - Scotty - DMa