The Beast ( BATTLESTAR PEGASUS )

[darkimmitator]

Well ,I couldn't stand it anymore ! I just couldn't live with the front engine slope being out 1/4 of an inch and having all those expensive kit parts ,not fitting right .( thanks Phil ,Jase ,and Mike ) So I cut the bottom of the front slope ,the frame joining the engine box to the body ,the rear of the steel armature by 1/4 of an inch . I then threw away all the forward trench angles ,and started from scratch again ! Now everything fits !!!! I even only have to use 3 plowblades instead of 3.5 like i WAS going to use before !! This is a load of relief , as I really didn't want to cut into the frame and loose structural integrity.It's actually stronger now as i reinforced some areas , used thicker styrene in all the angle plates of trench area ,and fixed another boo boo that I found and don't want to talk about ! LOL .Even the joints where all the angles intersect are cleaner and stronger .I am very happy with this refit .