|
Molding and casting
|
|
03-22-2010, 02:03 AM
There should be some kind of instruction manual that came with the mould kit. Usually, it's by weight from most manufacturers. There are some from http://www.smoothon.com that are by volume only, but those are a little more expensive than the regular casting supplies. Do you have a manufacturers' name?
|
| Messages In This Thread |
|
Molding and casting - by modelnutz - 11-09-2009, 03:23 AM
RE: Molding and casting - by bwayne64 - 11-14-2009, 04:56 AM
RE: Molding and casting - by modelnutz - 11-16-2009, 01:49 PM
RE: Molding and casting - by erospawn - 11-17-2009, 02:25 AM
RE: Molding and casting - by modelnutz - 11-21-2009, 11:05 AM
RE: Molding and casting - by bwayne64 - 11-21-2009, 10:27 AM
RE: Molding and casting - by erospawn - 12-22-2009, 10:00 AM
RE: Molding and casting - by erospawn - 12-22-2009, 10:20 AM
RE: Molding and casting - by modelnutz - 12-23-2009, 12:59 AM
RE: Molding and casting - by erospawn - 12-23-2009, 03:08 AM
RE: Molding and casting - by erospawn - 12-24-2009, 02:31 AM
RE: Molding and casting - by 427 Cobra - 12-23-2009, 02:36 AM
RE: Molding and casting - by 427 Cobra - 12-23-2009, 06:41 AM
RE: Molding and casting - by erospawn - 12-24-2009, 05:26 AM
RE: Molding and casting - by treker2557 - 03-20-2010, 11:12 AM
RE: Molding and casting - by modelnutz - 03-20-2010, 01:30 PM
RE: Molding and casting - by treker2557 - 03-20-2010, 02:38 PM
RE: Molding and casting - by JAWS - 03-21-2010, 10:47 AM
RE: Molding and casting - by treker2557 - 03-21-2010, 11:41 AM
RE: Molding and casting - by 427 Cobra - 03-21-2010, 11:42 AM
RE: Molding and casting - by erospawn - 03-21-2010, 12:19 PM
RE: Molding and casting - by 427 Cobra - 03-21-2010, 01:01 PM
RE: Molding and casting - by darkimmitator - 03-21-2010, 01:19 PM
RE: Molding and casting - by erospawn - 03-21-2010, 01:23 PM
RE: Molding and casting - by darkimmitator - 03-21-2010, 01:27 PM
RE: Molding and casting - by 427 Cobra - 03-22-2010, 02:03 AM
RE: Molding and casting - by darkimmitator - 03-22-2010, 06:49 AM
RE: Molding and casting - by ruby1058 - 02-08-2011, 01:31 PM
|
| Users browsing this thread: |
| 1 Guest(s) |