(12-29-2009, 08:48 AM)jasonwright.1972 Wrote: Yeah thats what I tried with originally. The resin on this kit is really dense. I think I just needed to remove more resin but the shapes are really dificult to hollow out as they cut in & out alot. I was going to scrap this build, as in just build it without lights & sell it off. Theres a 6' version being made & Im one for bigger is better! Im definately getting the 6'er. This was my first resin kit & a learning curve. I'll finish it just because I don't not like finishing projects. The casting wasn/isn't great with alot of details imperfect. Was one of the last cast off the original moulds. It has just recently been remoulded & fresh casting again...This kit really needs to be cast clear.
Why not take the Dremel tool, grind down the "inside" of the wall to make it thinner, then follow up with drilling with the pin vise. It may save on drill bits.
(Actually, you answered my question above
)