DeBoers Enterprise

[NemVia]

This month I've been concentrating on finishing up all of the major painting and/or Aztec patterns on the Enterprise Saucers. I have to say I am super Glad this is now pretty much behind me now. Just some minor touchups that need to be done, but most of these will be finished when the models are completely assembled. The next phase of these kits is the DECALS of both the upper and lower saucers as well as the engineering hulls. I was kind of taken aback with these kits when I finally realized that there are several decals that are not included with the decal page namely, the yellow areas for around the phaser turrets along with their Red outlines. I had to paint all of these on instead. I also had to paint on the Red stripes that go along the outside of the bridge area. But all of these colors are now painted on included the gray stripes where the dorsal meets the saucer and the gray stripe that encircles the bridge area back to the officer's lounge. The area around the windoes was painted Intermediate blue. After everything set, I then Gloss Coated all of the Painted areas with 2 coats to first seal all the paints so that it would be easier to handle the model pieces and also prepare the surface for the massive decaling that needed to be done. The upper and lower saucer and the engineering hulls all needed to be decaled. I believe when I counted up all the decals that needed to be applied and there were about 283 individual applications. Many of the single piece decals had to be cut as individuals, namely the ships name and registry numbers. The decal sheet has great graphics but the backing used is extremely thin and for some reason I needed to soak them a few minutes extra in order for it to seperate completely from the backing. But everything went on very smoothly. After the decals were added another light coat of gloss coat was then spritzed on and left to dry for about an hour, this will prevent the decals from sliding if the coat is too heavy. Then after another hour or so I put on the final coat and this sealed everything in place. There are 38 new pic in this months update.

Now I will be able to start on the interior lighting and adding the interior pieces to the model. I will first need to build some cradles to hold the models in place while I'm working on these areas. But the ships are finally going to be assembled during the next month. Even I'm looking forward to the update for next month! See you then!

Mark

http://www.NemVia.com